Assembling Steering Wheel

Information 

Multi-functional switches can be used immediately after installation. They do not need to be coded.

Information 

During assembly, make sure that the electric lines are routed correctly, particularly at potential chafing points.

1. Installation is performed in reverse order. Pay particular attention to the following:

1. 1.1  Screws for contact bridge:

   > Tightening torque 6 Nm (4.4 ftlb.) 

2. 1.2  Screws for rear cover:

   > Tightening torque 2.7 Nm (2 ftlb.) 

3. 1.3  Screws for rocker switches:

   > Tightening torque 2.5 Nm (1.8 ftlb.) 

4. 1.4  Screws for main cover:

   > Tightening torque 2 Nm (1.5 ftlb.) 

5. 1.5  Screws for multi-functional switches:

   > Tightening torque 0.45 Nm (0.3 ftlb.)