Installing Steering Wheel

Information 

• Turn wheels to straight-ahead position and observe the markings you applied earlier! 
• When replacing the steering wheel, replace the internal serration screw and secure according to tightening specifications. 

Installation is performed in reverse order. Pay particular attention to the following:

1. When fitting the steering wheel, make sure that the markings between the steering wheel and steering column are aligned.
2. Use new  internal serration screw -1-  and tighten as follows:

   > Initial tightening 30 Nm (22.1 ftlb.)  > Final tightening torque angle 90° 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Multiple-tooth screw