Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| PASM control unit to PASM control unit holder | Internal hexagon roundhead bolt, M5 x 12 | Tightening torque | 5.6 Nm (4.1 ftlb.) | ||
| PASM control unit holder to tunnel | Hexagon-head bolt, M6 x 14 | Tightening torque | 3 Nm (2 ftlb.) | ||
| PASM control unit holder to tunnel | Cap nut, M8 | Tightening torque | 9 Nm (6.5 ftlb.) |