LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2019 >> Cayenne S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 41 (42 Rear Wheel Suspension Drive Shaft 3.0L -- 9YA - Cayenne (9YA)) >> WM, 429019 Removing And Installing Anti-Roll Bar >> Installing Anti-Roll Bar

Installing Anti-Roll Bar

WARNING: This page is about a different variant/trim than selected.
  1. Installation is performed in reverse order. Pay particular attention to the following:
    1. 1.1  Tighten screws on anti-roll bar clamps.

      > Initial tightening 25 Nm (22 ftlb.) (18.4 ftlb.) 

      > Final tightening torque + 90° 

scientia non olet · About LEMON Manuals