Installing Strut

WARNING: This page is about a different variant/trim than selected.

Installation is performed in reverse order. Pay particular attention to the following:
1. 1.1 Tighten screw securing rear strut to the body.
  > Initial tightening 50 Nm (36.9 ftlb.)
  
  > Final tightening + 45 (33 ftlb.) °
2. 1.2 Tighten screw securing left strut to right strut.
  > Tightening torque 25 Nm (18.5 ftlb.) (18.4 ftlb.)
3. 1.3 Tighten screws securing front strut to the body.
  > Tightening torque 49 Nm (36.1 ftlb.)
4. 1.4 Tighten screws securing strut and rear axle housing to the body.
  > Initial tightening 130 Nm (96 ftlb.)
  
  > Final tightening + 180°