Installing Bypass Flap Control Box
WARNING: This page is about a different variant/trim than selected.
Information
The procedure for removing and installing is described for one side as an example. The procedure for the other side is almost identical.
- Install control box -1-
.
- 1.1
If a new control box is installed:
Pre-set control rod -5-
to the length of the old control box.
- 1.2
Position control box -1-
and tighten nuts -4-
.
> Tightening torque 8 Nm (6 ftlb.)
- 1.3
Clip in new circlip -3-
.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
Control box for bypass flap