LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2019 >> Cayenne S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 38 (21 Exhaust Gas Turbocharging 4.0L -- 9YA - Cayenne (9YA)) >> WM, 213919 Removing And Installing Moulded Hose (V8 BITURBO) >> Installing Moulded Hose

Installing Moulded Hose

WARNING: This page is about a different variant/trim than selected.
  1. Installation is performed in reverse order. Pay particular attention to the following:
    1. 1.1  Tighten the screw clamps of the moulded hose at the bottom to > Tightening torque 8 Nm (6 ftlb.)  .
    2. 1.2  Tighten the screw clamps of the moulded hose at the top to > Tightening torque 5.5 Nm (4.1 ftlb.)  .
scientia non olet · About LEMON Manuals