Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Screw for torque support bracket | M8 x 55/(V6 Turbo: M8 x45) | Tightening torque | 23 Nm (17 ftlb.) | ||
| Torque support bracket upper part to lower part | M10 x35 | Tightening torque | 55 Nm (41 ftlb.) | ||
| Fastening screws for heat shield on cylinder head cover, inner | M6 x 12 | Tightening torque | 9 Nm (6.5 ftlb.) | ||
| Fastening nut securing ground line to ignition coil | M6 | Tightening torque | 9 Nm (6.5 ftlb.) (6.6 ftlb.) | ||
| Screw for clamp for high-pressure line | M6 x 12 | Tightening torque | 9 Nm (6.5 ftlb.) | ||
| Union nut for fuel high-pressure line | Coat thread on union nuts with Microgleit DF 977S. Leave to dry off for at least 5 minutes before fitting. Observe specified tightening sequence! | Initial tightening | 8 Nm (6 ftlb.) | ||
| Union nut for fuel high-pressure line | Final tightening | + 50° |