Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Screw for high-pressure pump | M6 x 22 | Tightening torque | 12 Nm (9 ftlb.) | ||
| Union nut for fuel low-pies-sure line | Coat thread on union nuts with Microgleit DF 977S. Observe drying time of at least 5 minutes before fitting. Observe specified tightening sequence! | Initial tightening | 8 Nm (6 ftlb.) | ||
| Union nut for fuel low-pressure line | Final tightening | + 50° |