Installing Charging Socket
WARNING: This page is about a different variant/trim than selected.
WARNING:
Incorrect handling of high-voltage components
- Electric shock
- Short circuit
- Fire
- Explosion
- → Only appropriately trained and authorised persons are permitted to work on high-voltage vehicles and components.
- → Required qualification: High voltage technician or high voltage expert.
- → Observe national requirements and legislation for this work.
- → Always use insulated tools, e.g. > VAS 6883 - Insulated Tool Set when working on these components.
- → Observe general warning notes for working on the high-voltage system.
- → > WM, 2X00IN GENERAL WARNING NOTES FOR WORKING ON THE HIGH-VOLTAGE SYSTEM
Information
Make sure that the water drain is not kinked.
- Installation is performed in reverse order. Pay particular attention to the following:
Tighten screws securing charging socket to charging socket holder to > Tightening torque 5.6 Nm (4.1 ftlb.)
Tighten screws securing charging socket holder to body to > Tightening torque 6 Nm (4.4 ftlb.)
Electric plug connections must engage securely.