Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Screw for torque support bracket | M8 x 55/(V6 Turbo: M8 x 45) | Tightening torque | 23 Nm (17 ftlb.) | ||
| Torque support bracket upper part to lower part | M10 x 35 | Tightening torque | 55 Nm (41 ftlb.) | ||
| Low-pressure fuel line distributor | Coat thread on union nuts with Microgleit DF 977S. Observe drying time of at least 5 minutes before fitting. | Torque angle | 60° | ||
| Fastening screw for fuel line support | M6 x 12 | Tightening torque | 9 Nm (6.6 ftlb.) | ||
| Union nut for fuel line | Coat thread on union nuts with Microgleit DF 977S. Observe drying time of at least 5 minutes before fitting. | tightening torque of | 10 Nm (7.4 ftlb.) |