Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Fastening screw for low-pressure line support | M6 x 12 | Tightening torque | 9 Nm (6.6 ftlb.) | ||
| Fastening screw for high-pressure fuel line | Replace | tightening torque | 8 Nm (5.9 ftlb.) | ||
| Fastening screw for high-pressure fuel line | final tightening torque | 45° | |||
| Union nut for fuel line | Coat thread on union nuts with Microgleit DF 977S. Observe drying time of at least 5 minutes before fitting. | tightening torque of | 10 Nm (7.4 ftlb.) | ||
| Union nut for fuel line | Coat thread on union nut with Microgleit DF 977S. Observe drying time of at least 5 minutes before fitting. | Torque angle | 60° |