Oxygen Sensor Downstream Of Catalytic Converter
WARNING: This page is about a different variant/trim than selected.
Information
- When re-installing oxygen sensors, only grease the thread with lubricant (see PET).
- Make sure that the lubricant does not get into the slits in the sensor body.
- New oxygen sensors have already been greased and the thread is fitted with a protection cap.
- Installation is performed in reverse order. Pay particular attention to the following:
- 1.1
Tighten oxygen sensor downstream of catalytic converter.
> Tightening torque 52 Nm (38 ftlb.)
- 1.1
Tighten oxygen sensor downstream of catalytic converter.