Subsequent Work

WARNING: This page is about a different variant/trim than selected.

Only for vehicles with petrol particle filter

Carry out particle filter regeneration.
> 267429 REGENERATING PARTICLE FILTER

All vehicles
Adapt sensor wheel.
Only for R4:
1. 3.1 Connect PIWIS Tester to the vehicle.
2. 3.2 Select Engine electronics (DME) control unit.
3. 3.3 Select Maintenance/repairs tab
4. 3.4 Perform sensor wheel adaptation.
5. 3.5 Follow the instructions on the PIWIS Tester.
Information
- After removing, installing or replacing, perform the "Sensor wheel adaptation" function using the PIWIS Tester.
- To actively teach the adaptation, perform an adaptation drive together with another person.
Only for V6T and V8T:
1. 4.1 Select Engine electronics (DME) control unit.
2. 4.2 Select Maintenance/repairs tab
3. 4.3 Perform Sensor wheel adaptation reset.
4. 4.4 Perform sensor wheel adaptation with an adaptation drive.
1. 4.4.1 Get a second person to check the PIWIS Teste while you are driving.
2. 4.4.2 Select Engine electronics (DME) control unit.
3. 4.4.3 Select the "Actual values/input signals" tab.
4. 4.4.4 Select the information "General".
5. 4.4.5 Select the actual value "Engine speed and engine torque".
6. 4.4.6 Select the "Misfiring" information.
7. 4.4.7 Note the actual value "Segment adaptation for rough running, status".
  Value "0" = adapted and (value "2" = not adapted)
8. 4.4.8 Perform adaptation drive until actual value segment adaptation for rough running, status displays "0" → Adaptation is complete.
  This procedure must be carried out at least 11 x.
9. 4.4.9 Bring combustion engine to operating temperature.
10. 4.4.10 Set "Normal" drive mode with "Manual" transmission mode in 2nd gear.
11. 4.4.11 Engine speed → 1600 and 2400 rpm.
12. 4.4.12 Generate a minimal load (50 to 150 Nm/37 to 111 ftlb.) → slight acceleration or slight uphill driving for at least three seconds each.
13. 4.4.13 Overrun phase (accelerator pedal not pressed, no fuel injection) for at least two seconds each.