LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2019 >> Cayenne S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (24 Fuel System - Electronic Injection 3.0L -- 9YA - Cayenne (9YA)) >> WM, 244619 Removing And Installing Centre Intake-Air Distributor (V6 MONOTURBO) >> Installing Centre Intake-Air Distributor

Installing Centre Intake-Air Distributor

WARNING: This page is about a different variant/trim than selected.
  1. installation is performed in reverse order. Pay particular attention to the following:
    1. 1.1  Check sealing rings for centre intake-air distributor at the intake-air distributor and replace them if damaged.
    2. 1.2  Tighten top screw on centre intake-air distributor.

      > Tightening torque 8 Nm (6 ftlb.) 

    3. 1.3  Tighten screws securing centre intake-air distributor to side intake-air distributors.

      > Tightening torque 7 Nm (5 ftlb.) 

scientia non olet · About LEMON Manuals