Subsequent Work
WARNING: This page is about a different variant/trim than selected.
- Check engine coolant level and correct it if necessary.
- Read out the fault memories of all control units, work through any fault entries and then clear the fault memories.
- Remove battery charger.
- Test-drive the vehicle and then check the engine coolant level in the reservoir.
- Close the coolant reservoir -1- .
Coolant reservoir for low-temperature cooling system
- 5.1 Close the cap on the coolant reservoir -2- .
- 5.2 Wrap seal -3- through the bore on the cap -2- and around the coolant hose connection -4- .
- 5.3 Close off seal -3- .
- 5.4 Check that the warning sign -5- is attached and attach it if necessary.