LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2019 >> Cayenne S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 27 (40 Wheel Suspension Front Drive Shaft 3.0L -- 9YA - Cayenne (9YA)) >> WM, 404137 Disassembling And Assembling Front Drive Shaft >> Disassembling And Assembling Front Drive Shaft >> Assembling Drive Shaft

Assembling Drive Shaft

WARNING: This page is about a different variant/trim than selected.
  1. Installation is performed in reverse order. Pay particular attention to the following:
    1. 1.1  Fit new bellows on the drive shaft.
    2. 1.2  Replace circlips.
    3. 1.3  Fit the joint at the wheel side as far as it will go onto the drive shaft using a rubber hammer.

      Information 

      Do not position brass mandrel on the 3 rollers of the joint!

    4. 1.4  Fit the joint at the transmission side as far as it will go onto the drive shaft using a brass mandrel by tapping gently with a hammer.
    5. 1.5  Apply new grease (see Parts Information) on the joints and bellows.
      Engine type Quantity of grease on joint at the wheel side Quantity of grease on joint at the transmission side V6 (not PHEV) > Quantity > Quantity
        128g + 10g 130g + 10g
      R4 PHEV  > Quantity > Quantity
      V6 PHEV  194g + 10g 190g + 5g
      V8 (not PHEV)     
      V8 PHEV  > Quantity 252g + 10g > Quantity 192g + 10g s-<
    6. 1.6  Fit new hose clamps using > V.A.G 1275A - Hose clip pliers  (position hose clamps at the grooves provided).
scientia non olet · About LEMON Manuals