Installing Supply Line - Section From Engine To High-Pressure Pump
WARNING: This page is about a different variant/trim than selected.
- Installation is performed in reverse order. Pay particular attention to the following:
- 1.1
Tighten nuts on fuel line bracket.
> Tightening torque 9 Nm (6.6 ftlb.)
- 1.2
Tighten screw on line bracket.
> Tightening torque 8 Nm (5.9 ftlb.) > final tightening torque 45°
- 1.3
Tighten union nut on supply line.
> Tightening torque of 10 Nm (7.4 ftlb.)
- 1.1
Tighten nuts on fuel line bracket.