Subsequent Work

Only for installing upper chain housing cover on right cylinder bank: 

1. Install additional coolant pump holder.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Additional coolant pump (right cylinder bank)

   1. 1.1  Position additional coolant pump holder -1-  , fit double screw securing holder to chain housing cover -3-  and tighten it.

      > Tightening torque 9 Nm (6.5 ftlb.) 

   2. 1.2  Fit and tighten screws securing additional coolant pump to holder -2-  .

      > Tightening torque 1.5 Nm (1 ftlb.) 

2. Install primary catalytic converter(s).

   > 267619 REMOVING AND INSTALLING PRIMARY CATALYTIC CONVERTER (V6 MONOTURBO)

   > 267619 REMOVING AND INSTALLING PRIMARY CATALYTIC CONVERTER (V6 BITURBO)

3. Install the engine.

   > 100119 REMOVING AND INSTALLING ENGINE

4. Fill up coolant.

   > Refer to the appropriate service information.