Brake Disc Measurement Sheet
WARNING: This page is about a different variant/trim than selected.
A copy or print-out of the data card shown here can be used to document the measured result. The data cards cannot be ordered.
- Make a copy or print-out of the data card shown here.
Information
- Actual values that are identical in all versions are already entered!
- Before taking measurements (Test 1 to Test 3), enter the general data, vehicle type and the missing nominal values (new brake disc thickness/brake disc wear limit) in the data card.
- Carry out measurements (actual status) and enter the values in the data card.
- If brake discs are to be replaced, carry out Test 2 with the new discs again and enter the latest values in a new data card.
| Brake disc measurement | |||
|---|---|---|---|
| Customer: | Rep. Order No.: | ||
| Street: | Porsche VIN: | ||
| City: | Reg. number: | ||
| Telephone: | Date of first registration: | ||
| Vehicle type: | Odometer reading [km/miles]: | ||
| Checker: | Date/Signature | ||
| Nominal values | |||
| Test 1 = Brake disc thickness | |||
|
Front: Rear: | ||
|
Front: Rear: | ||
| Test 2 = Lateral runout | |||
|
max.: | ||
|
max.: 0.02 | ||
|
max.: 0.03 | ||
| Test 3 = Thickness tolerance of brake disc | |||
| Thickness tolerance of brake disc [mm] | max.: | ||
| Measured values (actual values) [mm] | front left front right rear left rear right | ||
| Test 1 = brake disc thickness (number of measuring points can vary depending on the measuring method) | |||
| Measurement point 1 | |||
| Measurement point 2 | |||
| Measurement point 3 | |||
| Measurement point 4 | |||
| Measurement point 5 | |||
| Measurement point 6 | |||
| Measurement point 7 | |||
| Test 2 = Lateral runout | |||
|
|||
|
|||
|
|||
| Test 3 = Thickness tolerance of brake disc(1) | |||
| Thickness tolerance(1) | |||
|
|||