Installing Piston Spray Nozzle Control Valve
WARNING: This page is about a different variant/trim than selected.
- Installation is performed in reverse order. Pay particular attention to the following:
- 1.1 Replace sealing ring on piston spray nozzle control valve following removal.
- 1.2
Tighten screw on piston spray nozzle control valve.
> Tightening torque 9 Nm (6.5 ftlb.)
- 1.3
Tighten screws on heat shield.
> Tightening torque 9 Nm (6.5 ftlb.)