LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2019 >> Cayenne S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (21 Exhaust Gas Turbocharging 3.0L -- 9YA - Cayenne (9YA)) >> WM, 212419 Removing And Installing Intake Manifold (V6 MONOTURBO) >> Installing Intake Manifold

Installing Intake Manifold

WARNING: This page is about a different variant/trim than selected.
  1. Installation is performed in reverse order. Pay particular attention to the following:
    1. 1.1  Replace O-rings.
    2. 1.2  Tighten screws on intake manifold.

      > Tightening torque 9 Nm (6.5 ftlb.) 

    3. 1.3  Tighten screw-type clamp securing suction hose to intake manifold.

      > Tightening torque 3.5 Nm (2.5 ftlb.) 

scientia non olet · About LEMON Manuals