Preliminary Work
WARNING: This page is about a different variant/trim than selected.
- Remove front apron.
- Remove headlight.
- Mark installation position of headlight mounting on cross member.
- Remove headlight mounting -1-
.
Headlight mounting
- 4.1 Unscrew fastening screws -2 and 3- .
- 4.2 Remove headlight mounting -1- .
- Remove (upper) cooling-air flaps.
> 193519 REMOVING AND INSTALLING COOLING-AIR FLAPS (TOP) - information on "Removing"
- Loosen cross member -1- .
Cross member
- 6.1 Unclip cross member -1- (-Arrows- ).
- 6.2 Set cross member -1- with electric lines connected down on the lock carrier.