Installing Catalytic Converter
WARNING: This page is about a different variant/trim than selected.
- Installation is performed in reverse order. Pay particular attention to the following:
- 1.1 Replace seal on exhaust flange.
- 1.2 Screws on exhaust bracket:
> Tightening torque 23 Nm (17 ftlb.)
- 1.3 Clamp securing catalytic converter to exhaust system:
> Tightening torque 23 Nm (17 ftlb.)
- 1.4 Screw on catalytic converter holder:
> Tightening torque 23 Nm (17 ftlb.)
- 1.5 New
nuts:
> Tightening torque 23 Nm (17 ftlb.)