Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | De... | Type | Basic v... | Toleran... | Toleran... |
|---|---|---|---|---|---|
| Aluminium screw securing air-conditioning compressor bracket to crankcase | Replace following removal. | Initial tightening | 8 Nm (6 ftlb.) | ||
| Aluminium screw securing air-conditioning compressor bracket to crankcase | Replace following removal. | Final tightening | + 90° | ||
| Screws on return line adapter | Tightening torque | 9 Nm (6.5 ftlb.) | |||
| Screws on supply line adapter | Tightening torque | 9 Nm (6.5 ftlb.) | |||
| Screw for belt tensioner (air-conditioning compressor) | M8 x 33 | Tightening torque | 25 Nm (19 ftlb.) | ||
| Screw for deflection roller (generator) | M8 x 16.9 x 65 x 50 | Tightening torque | 25 Nm (19 ftlb.) | ||
| Screw securing oil windage tray to crankcase | M6 x 18 (3 ea.)/rep lace, tighten crosswise | Initial tightening | 3 Nm (2 ftlb.) | ||
| Screw securing oil windage tray to crankcase | M6 x 18 (3 ea.)/rep lace, tighten crosswise | Final tightening | + 90° | ||
| Screw securing oil windage tray to crankcase | M6 x 30 (13 ea.)/rep lace, tighten crosswise | Initial tightening | 3 Nm (2 ftlb.) | ||
| Screw securing oil windage tray to crankcase | M6 x 30 (13 ea.)/rep lace, tighten crosswise | Final tightening | + 90° | ||
| Screw securing chain housing cover to oil windage tray | M6 x 25 (2 ea.)/rep lace, observe tightening sequence | Initial tightening | 3 Nm (2 ftlb.) | ||
| Screw securing chain housing cover to oil windage tray | M6 x 25 (2 ea.)/rep lace, observe tightening sequence | Final tightening | + 90° | ||
| Banjo bolt for oil spray jet | Initial tightening | 10 Nm (7.5 ftlb.) | |||
| Banjo bolt for oil spray jet | Final tightening | + 45° | |||
| Screws on coolant control valve | Tightening torque | 9 Nm (6.5 ftlb.) | |||
| Aluminium screw securing generator bracket to engine | M8 x 40/replace | Initial tightening | 8 Nm (6 ftlb.) | ||
| Aluminium screw securing generator bracket to engine | M8 x 40 | Final tightening | + 90° |