Mounting Engine

WARNING: This page is about a different variant/trim than selected.

WARNING: Danger of objects or loads falling down

Risk of squashing or crushing
1. → Secure components to prevent them from falling down.

Information

Get another person to help during removal and mounting.

Installation is performed in reverse order. Pay particular attention to the following:
1. 1.1 When positioning the engine, make sure that the engine supports are not touching the front-axle carrier.
2. 1.2 When positioning the engine, make sure that no electric lines are crushed.
3. 1.3 Tighten new screws securing engine mounts to engine support.
  > Initial tightening 90 Nm (66.4 ftlb.)
  
  > Final tightening + 90°
4. 1.4 V6 only:
Tighten screws on supporting mounts.

> Torque 20 Nm (14.8 ftlb.)