Vehicle Height With Steel Springs
WARNING: This page is about a different variant/trim than selected.
Information
- The following values refer to the DIN empty weight (DIN 70020), in other words: full fuel tank, vehicle with tyre sealant (or spare wheel, collapsible wheel) and tools, with no occupants and no luggage.
- Tyre pressure in accordance with specifications.
- On vehicles with air suspension, the vehicle must be adjusted to normal level using the Porsche System Tester. Only align and adjust the vehicle in this position.
- If the control unit or one of the level sensors was replaced, calibration must be carried out using the Porsche System Tester.
| Vehicle height | Steel springs, Basic | Steel springs, Basic | Steel springs, GTS |
|---|---|---|---|
| PR No. | 1BA - conventional, Basic | 1BH - PASM, Basic | 1BE - PASM, GTS |
| Vehicle heights ISO 1176 - M06 in mm | |||
| Front-axle height | |||
| with 19, 20, 21, 22-inch wheels [mm] | 471 ± 10 | 471 ± 10 | 451 ± 10 |
| From outer wheel center to bottom edge of wing | |||
| Rear-axle height | |||
| with 19, 20, 21, 22-inch wheels [mm] | 473 ± 10 | 473 ± 10 | 453 ± 10 |
| From outer wheel center to bottom edge of wing | |||
| Maximum difference in height, left to right. 10 mm |