Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Front axle carrier on front body | Item 2: M12 hexagon-head bolt x 1.5 x 90/Always replace screws following removal! | Initial tightening torque | 115 Nm (84.8 ftlb.) | ||
| Front axle carrier on front body | Item 2: M12 hexagon head bolt x 1.5 x 90/Always replace bolts following removal! | Final tightening torque | + 90° | ||
| Front axle carrier on rear body | Item 3: M14 hexagon-head bolt x 1.5 x 100/Always replace screws following removal! | Initial tightening torque | 130 Nm (95.9 ftlb.) | ||
| Front axle carrier on rear body | Item 3: M14 hexagon head bolt x 1.5 x 100/Always replace bolts following removal! | Final tightening torque | + 180° | ||
| Heat insulation on front axle carrier | Hexagon-head bolt M6 x 16 | Tightening torque | 9 Nm (6.6 ftlb.) | ||
| Heat insulation to longitudinal chassis beam | Hex bolt M6 x 12/applies to one-piece heat insulation. | Tightening torque | 9 Nm (6.5 ftlb.) (6.6 ftlb.) | ||
| Heat insulation (upper part) to heat insulation (lower part) | M6 hex bolt x 20/applies to two-piece heat insulation! | Tightening torque | 9 Nm (6.5 ftlb.) (6.6 ftlb.) | ||
| Heat insulation (upper part) to longitudinal chassis beam | M6 hex bolt x 20/applies to two-piece heat insulation! | Tightening torque | 9 Nm (6.5 ftlb.) (6.6 ftlb.) | ||
| Steering tie rod on rear axle beam/servo motor for rear axle steering (toe eccentric) | Item 4: Eccentric screw, M12 x 1.5 with eccentric washer and hexagon nut | Tightening torque | 90 Nm (66 ftlb.) (66.4 ftlb.) | ||
| Axle link on rear axle beam (camber eccentric) | Item 3: Eccentric screw, M14 x 1.5 with eccentric washer and hexagon nut | Tightening torque | 140 Nm (103 ftlb.) (103.3 ftlb.) | ||
| Tie rod ball to tie rod (toe adjustment) | M16 x 1.5 thread | Tightening torque | 80 Nm (59 ftlb.) |