Installing Oil Pump

WARNING: This page is about a different variant/trim than selected.

Installation is performed in reverse order. Pay particular attention to the following:
1. 1.1 Fit new seal on oil pump.
2. 1.2 Replace screws for oil pump and screw for sprocket at the oil pump.
3. 1.3 Tighten screws on oil pump.
  > Initial tightening 8 Nm (6 ftlb.)
  
  > Final tightening + 90°
4. 1.4 Tighten screw securing sprocket to oil pump.
  > Initial tightening 20 Nm (15 ftlb.)
  
  > Final tightening + 90°