Installing front three-point belt
WARNING: This page is about a different car, the 2023 Porsche Cayenne, 2022 Porsche Cayenne, 2021 Porsche Cayenne, and 2020 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
Information
Do not twist the three-point seat belt during installation.
Information
Once the screw has been tightened, the belt deflector must level out on its own in a vertical position or in the relevant support direction.
Information
Route electric lines outside of the belt roll-up area.
Information
Always replace screws on the three-point seat belt. Micro-self-locking screws must not be treated (greased) or loosened and then screwed on again.
- Installation is performed in reverse order. Pay particular attention to the following:
Screw in fastening screws and tighten to > Tightening torque 40 Nm (30 ftlb.) .
Screw in fastening screws and tighten to > Tightening torque 40 Nm (30 ftlb.) .
Screw in fastening screws and tighten to > Tightening torque 40 Nm (30 ftlb.) .