| Front axle carrier on front body |
Item 2: M12 hexagon-head bolt x 1.5 x 90/Always replace screws following removal! |
Initial tightening torque |
115 Nm (84.8 ftlb.) |
|
|
| Front axle carrier on front body |
Item 2: M12 hexagon head bolt x 1.5 x 90/Always replace bolts following removal! |
Final tightening torque |
+ 90° |
|
|
| Front axle carrier on rear body |
Item 3: M14 hexagon-head bolt x 1.5 x 100/Always replace screws following removal! |
Initial tightening torque |
130 Nm (95.9 ftlb.) |
|
|
| Front axle carrier on rear body |
Item 3: M14 hexagon head bolt x 1.5 x 100/Always replace bolts following removal! |
Final tightening torque |
+ 180° |
|
|
| Heat insulation on front axle carrier |
Hexagon-head bolt M6 x 16 |
Tightening torque |
9 Nm (6.6 ftlb.) |
|
|
| Heat insulation to longitudinal chassis beam |
Hex bolt M6 x 12/applies to one-piece heat insulation. |
Tightening torque |
9 Nm (6.5 ftlb.) (6.6 ftlb.) |
|
|
| Heat insulation (upper part) to heat insulation (lower part) |
M6 hex bolt x 20/applies to two-piece heat insulation! |
Tightening torque |
9 Nm (6.5 ftlb.) (6.6 ftlb.) |
|
|
| Heat insulation (upper part) to longitudinal chassis beam |
M6 hex bolt x 20/applies to two-piece heat insulation! |
Tightening torque |
9 Nm (6.5 ftlb.) (6.6 ftlb.) |
|
|
| Steering tie rod on rear axle beam/servo motor for rear axle steering (toe eccentric) |
Item 4: Eccentric screw, M12 x 1.5 with eccentric washer and hexagon nut |
Tightening torque |
90 Nm (66 ftlb.) (66.4 ftlb.) |
|
|
| Axle link on rear axle beam (camber eccentric) |
Item 3: Eccentric screw, M14 x 1.5 with eccentric washer and hexagon nut |
Tightening torque |
140 Nm (103 ftlb.) (103.3 ftlb.) |
|
|
| Tie rod ball to tie rod (toe adjustment) |
M16 x 1.5 thread |
Tightening torque |
80 Nm (59 ftlb.) |
|
|