Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location |
Description |
Type |
Basic value |
Tolerance 1 |
Tolerance 2 |
| Screw for heat shield on additional coolant pump |
M6 |
Tightening torque |
9 Nm (6.5 ftlb.) |
|
|
| Oil lines to transmission |
Screw, M8 x 28 |
Tightening torque |
20 Nm (15 ftlb.) |
|
|
| Double screw for additional coolant pump (high-temperature system P2) |
M6 x 14/M6 x 14 |
Tightening torque |
9 Nm (6.6 ftlb.) |
|
|
| Torque converter to drive plate |
Screw, M10 x 1 x 15.5 -observe mounting specification! |
Tightening torque |
60 Nm (44 ftlb.) |
|
|
| Transmission to engine flange |
Screws, M 12 x 100 (Item 2-6) and M12 x 125 (Item 7) -Replace aluminium screws |
Initial tightening torque |
30 Nm (22 ftlb.) |
|
|
| Transmission to engine flange |
Screws, M12 x 100 (Item 2-6) and M12 x 125 (Item 7) -Replace aluminium screw |
Final tightening torque angle |
90 Grad |
|
|
| Transmission to engine flange |
Screws, M10 x 60 (Item 8 and 11), M10 x 75 (Item 9), M10 x 95 (Item 10) - replace aluminium screws |
Initial tightening torque |
15 Nm (11 ftlb.) |
|
|
| Location |
Description |
Type |
Basic value |
Tolerance |
Tolerance |
| Transmission to engine flange |
Screws, M10 x 60 (Item 8 and 11), M10 x 75 (Item 9), M10 x 95 (Item 10) - replace aluminium screws |
Final tightening torque angle |
90 Grad |
|
|
| Starter pinion cover |
Screw M10 x 25/N.91 1.472.01 |
Tightening torque |
20 Nm (14.75 ftlb.) |
|
|
| Screw for starter, bottom |
M10 x 50 |
Tightening torque |
65 Nm (48 ftlb.) |
|
|