Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Brake calliper to wheel bearing housing | Cheese head bolt, M14/always replace screws or bolts following removal | Initial tightening | 30 Nm (22 ftlb.) | ||
| Brake calliper to wheel bearing housing | Cheese head bolt, M14/always replace screws or bolts following removal | Final tightening | + 90° | ||
| Brake line to brake calliper | Union nut, M10 x 1 | Tightening torque | 14 Nm (10.5 ftlb.) | ||
| Cable holder to wheel bearing housing | Internal serration screw, M8 x 25 | Tightening torque | 20 Nm (15 ftlb.) |