Replacing Rear Logo
WARNING: This page is about a different car, the 2023 Porsche Cayenne, 2022 Porsche Cayenne, 2021 Porsche Cayenne, and 2020 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
- Heat the area around the rear logo using > V.A.G 1416 - Hot-Air Blower .
- Prise off rear logo using a plastic spatula.
- Remove adhesive residue from around the rear logo using silicone remover.
Information
- Carefully clean any dirt, grease, wax and other impurities off the fitting area of the body using isopropanol.
- Always use a clean cloth.
- The room and object temperature must be at least > Nominal value + 15°C .
- Air humidity must be > Nominal value 50 % +/- 10 % .
- Do not touch the bonding surface again after removing the protective paper.
- Wear clean gloves during the bonding process in order to guarantee adequate adhesion.
- The parts must have been bonded for at least > Nominal value 72 h before washing the vehicle in a car wash.
- Position logo rear using logo template and interchangeable insert.
> 9967 - Logo template "Cayenne"
> 9967/1 - Logo template "Cayenne" e-hybrid
> 9967/2 - Logo template "Cayenne S"
> 9967/3 - Logo template "Cayenne turbo"
> 9967/4 - Logo template "Cayenne turbo S"
> 9967/5 - Logo template "Cayenne GTS"
> 9977 - Logo template "Cayenne" (Coupe)
> 9977/1 - Logo template "Cayenne S" (Coupe)
> 9977/2 - Logo template "Cayenne turbo" (Coupe)
> 9977/3 - Logo template "Cayenne" e-hybrid (Coupe)
> 9977/4 - Logo template "Cayenne turbo S" (Coupe)
> 9977/5 - Logo template "Cayenne GTS" (Coupe)
> 9977/6 - Logo template "turbo GT" Cayenne (Coupe)