| Double screw for additional coolant pump (run-on) |
M6 x 14/M6 x 14 |
Tightening torque |
9 Nm (6.5 ftlb.) |
|
|
| Screws securing additional coolant pump (run-on) to holder |
|
Tightening torque |
1.5 Nm (1 ftlb.) |
|
|
| Screws for coolant pipe on left cylinder bank |
|
Tightening torque |
9 Nm (6.5 ftlb.) |
|
|
| Screw for chain housing cover on cylinder bank 1 |
M6 x 22 (8 ea.)/replace, observe specified tightening sequence |
Tightening torque |
9 Nm (6.5 ftlb.) |
|
|
| Screw for chain housing cover on cylinder bank 2 |
M6 x 22 (7 ea.)/replace, observe specified tightening sequence |
Tightening torque |
9 Nm (6.5 ftlb.) |
|
|
| Fastening screw for high-pressure fuel line |
Replace |
tightening torque |
8 Nm (5.9 ftlb.) |
|
|
| Fastening screw for high-pressure fuel line |
|
final tightening torque |
45° |
|
|
| Union nut for fuel line |
Coat thread on union nuts with Microgleit DF 977S. Observe drying time of at least 5 minutes before fitting. |
tightening torque of |
10 Nm (7.4 ftlb.) |
|
|
| Union nut for fuel line |
Coat thread on union nut with Microgleit DF 977S. Observe drying time of at least 5 minutes before fitting. |
Torque angle |
60° |
|
|