| Aluminium screw securing air-conditioning compressor bracket to crankcase |
Replace following removal. |
Initial tightening |
8 Nm (6 ftlb.) |
|
|
| Aluminium screw securing air-conditioning compressor bracket to crankcase |
Replace following removal. |
Final tightening |
+ 90° |
|
|
| Screws on return line adapter |
|
Tightening torque |
9 Nm (6.5 ftlb.) |
|
|
| Screws on supply line adapter |
|
Tightening torque |
9 Nm (6.5 ftlb.) |
|
|
| Screw for belt tensioner (air-conditioning compressor) |
M8 x 33 |
Tightening torque |
25 Nm (19 ftlb.) |
|
|
| Screw for deflection roller (generator) |
M8 x 16.9 x 65 x 50 |
Tightening torque |
25 Nm (19 ftlb.) |
|
|
| Screw securing oil windage tray to crankcase |
M6 x 18 (3 ea.)/rep lace, tighten crosswise |
Initial tightening |
3 Nm (2 ftlb.) |
|
|
| Screw securing oil windage tray to crankcase |
M6 x 18 (3 ea.)/rep lace, tighten crosswise |
Final tightening |
+ 90° |
|
|
| Screw securing oil windage tray to crankcase |
M6 x 30 (13 ea.)/rep lace, tighten crosswise |
Initial tightening |
3 Nm (2 ftlb.) |
|
|
| Screw securing oil windage tray to crankcase |
M6 x 30 (13 ea.)/rep lace, tighten crosswise |
Final tightening |
+ 90° |
|
|
| Screw securing chain housing cover to oil windage tray |
M6 x 25 (2 ea.)/rep lace, observe tightening sequence |
Initial tightening |
3 Nm (2 ftlb.) |
|
|
| Screw securing chain housing cover to oil windage tray |
M6 x 25 (2 ea.)/rep lace, observe tightening sequence |
Final tightening |
+ 90° |
|
|
| Banjo bolt for oil spray jet |
|
Initial tightening |
10 Nm (7.5 ftlb.) |
|
|
| Banjo bolt for oil spray jet |
|
Final tightening |
+ 45° |
|
|
| Screws on coolant control valve |
|
Tightening torque |
9 Nm (6.5 ftlb.) |
|
|
| Aluminium screw securing generator bracket to engine |
M8 x 40/replace |
Initial tightening |
8 Nm (6 ftlb.) |
|
|
| Aluminium screw securing generator bracket to engine |
M8 x 40 |
Final tightening |
+ 90° |
|
|