Installing Moulded Hose
- Installation is performed in reverse order. Pay particular attention to the following:
- 1.1
Tighten the screw clamps of the moulded hose at the bottom.
> Tightening torque 8 Nm (6 ftlb.)
- 1.2
Tighten the screw clamps of the moulded hose at the top.
> Tightening torque 5.5 Nm (4.1 ftlb.)
- 1.1
Tighten the screw clamps of the moulded hose at the bottom.