| diagonal arm to front-axle carrier |
Item 6: Hexagonal screw V.2 x 140 and hexagon nut/always replace screws and nuts following removal! |
Initial tightening |
70 Nm (51.6 ftlb.) |
|
|
| Diagonal arm to front-axle carrier |
Item 6: Hexagon-head screw M12 x 140 and hexagon nut/always replace bolts and nuts following removal! |
Final tightening |
+ 180° |
|
|
| Diagonal arm to wheel bearing housing |
Item 7: Hexagon nut M14 x 1.5/always replace nut following removal! |
Tightening torque |
140 Nm (103.3 ftlb.) |
|
|
| Heat insulation on front axle carrier |
Hexagon-head bolt M6 x 16 |
Tightening torque |
9 Nm (6.6 ftlb.) |
|
|
| Heat insulation to longitudinal chassis beam |
Hex bolt M6 x 12/applies to one-piece heat insulation. |
Tightening torque |
9 Nm (6.5 ftlb.) (6.6 ftlb.) |
|
|
| Heat insulation (upper part) to heat insulation (lower part) |
M6 hex bolt x 20/applies to two-piece heat insulation! |
Tightening torque |
9 Nm (6.5 ftlb.) (6.6 ftlb.) |
|
|
| Heat insulation (upper part) to longitudinal chassis beam |
M6 hex bolt x 20/applies to two-piece heat insulation! |
Tightening torque |
9 Nm (6.5 ftlb.) (6.6 ftlb.) |
|
|