Removing Padding For Rear Backrest (2/3-Split Folding Rear Seat)
- Unclip clips -1-
from seat cover for rear backrest -2-
at the bottom.
Seat cover on rear backrest
- Disconnect electric wire harness -2-
at the bottom of the seat frame.
Electric wire harness
- 2.1
Release and unplug electric plug connections -1-
.
Information
Mark installation positions!
- 2.2
Unclip electric wire harness -2-
on the seat frame at the bottom and remove it -Arrows-
.WARNING: Incorrect handling of safety bolts
- Danger of injury
- Loss of torque
- → Always use new screws or nuts following removal.
- → Comply with instructions for repairs.
- → Observe specified tightening torques.
- → Carry out a visual inspection of parts used.
- 2.1
Release and unplug electric plug connections -1-
.
- Unscrew screw -1-
and remove seat belt mount -2-
.
Seat belt mount
- Detach seat cover on rear backrest -1-
at the seat backrest.
Seat cover for rear backrest on seat backrest
- 4.1 Detach seat cover on rear backrest -1- from the groove in the seat backrest.
- 4.2 Feed electric wire harness -2- through the seat cover on the rear backrest -1- .
- Loosen Velcro fasteners -1-
from padding for rear backrest (2/3-split folding rear seat) and move seat cover for rear backrest -2-
forward.
Velcro fasteners
- Loosen clips -1-
and bend tab -2-
outwards.
Outer tab
- Loosen clip -1-
and bend tab -2-
outwards.
Inner tab
- Unclip cover -1-
.
Cover
- Unclip belt feed-through element -1-
and leave it hanging at the rear three-point belt for the middle seat.
Belt feed-through element
- Disengage clamping strips -1-
and detach seat cover on rear backrest -2-
from the backrest frame.
Seat cover on rear backrest
- Pull catcher -1-
down off the side airbag -2-
.
Side airbag catcher
- Remove headrest guide at the left -3-
.
Headrest guide, left
- 12.1 Press padding for rear backrest (2/3-split folding rear seat) -1- away from the backrest frame.
- 12.2 Release locking lug -2- and press left headrest guide -3- out of the backrest frame.
- Remove headrest guide at the right -2-
.
Headrest guide, right
- 13.1 Press padding for rear backrest (2/3-split folding rear seat) -1- away from the backrest frame -arrow A- .
- 13.2 Release headrest guide at the right -2-arrow B- and press it out of the backrest frame.
- Guide rear three-point belt for middle seat -2-
with belt feed-through element -1-
through the padding for the rear backrest (2/3-split folding rear seat) -3-
.
Rear three-point belt for middle seat
- Remove padding for rear backrest (2/3-split folding rear seat).