Replacing Windscreen Projection Control Unit

NOTIFICATION

Voltage drop

Irreparable damage to control unit
Damage to control unit
Fault entries in the control unit
Control unit programming/coding is aborted
Malfunctions in the control unit, even during programming
1. Switch off ignition before disconnecting the control unit.
2. Make sure that the power supply is not interrupted during programming/coding.
3. Connect the battery charger with at least > current 90 A to the vehicle battery.

Information

Ensure the consistency of a combination of hardware and software versions

After performing software updates, always make sure that the target software versions are also actually installed on the control units and that the system is therefore ensured.

This also applies in the case of hardware replacement.

See TI 9X00 Information on the software system for various control units in the vehicle (112/21)

Information

The PIWIS Tester instructions take precedence since the description may be different with later Tester releases.

The procedure described here has been structured in general terms. Different text or additional information may appear on the PIWIS Tester.

Connect the Tester to the vehicle and start it. Switch on ignition.
Select the vehicle type if necessary.
In the Overview, select the control unit in the Head-Up-Display. Press F12 to start. The message "Create Vehicle Analysis
Log (VAL)?" appears. Press F11 to continue.
Select Coding/programming.
Select Automatic coding. Press F12 to continue.
1. 5.1 The tester displays the message: Coding successfully performed.
Select Maintenance/repairs.
Commissioning must be selected. Press F12 to continue.
1. 7.1 Read and follow the instructions and information on the Tester.
2. 7.2 Calibrate head-up display according to menu guidance.
Go back to the Overview.
Read out all fault memories process and delete existing faults if necessary.
Exit the diagnostic application, switch off ignition, disconnect the Tester from the vehicle.