Installing ATF Cooler

Information 

• Aluminium screws must always be replaced. 
• Aluminium screws must be secured using the yield-strength procedure. 
• To ensure that the screws are tightened uniformly, the specified tightening setting "light, medium or hard" must be used. 
• The threshold torque (initial tightening) must be set on the  > 9768 - electronic torque wrench from 2 - 100 Nm (1.5 - 74 ftlb.) when tightening using the yield-strength procedure. 

1. Check seals on the oil lines and replace them if necessary.
2. Further installation is performed in reverse order to removal.

   Fastening screw securing holder for oil lines to transmission > Initial tightening + yield strength 6 Nm (4.5 ftlb.)  .

   Fastening screw securing ATF cooler to transmission > Initial tightening + yield strength 2.4 Nm (2 ftlb.)  .