Installing Front Brake CALLIPER Information
WARNING: This page is about a different variant/trim than selected.
Replace brake calliper fastening screws each time they are removed. Information
Information
Components that come into contact with brake fluid must be cleaned with brake cleaner.
IMPORTANT:
Brake pads that have been contaminated with brake fluid must be replaced.
- Installation is performed in reverse order to removal.
Fastening screws securing brake calliper to wheel carrier > Tightening torque 85 Nm (62.7 ftlb.)
Cap screw securing brake line to brake calliper > Tightening torque 16 Nm (11.8 ftlb.) .
Holder to wheel bearing housing > Tightening torque 10 Nm (7.5 ftlb.) .