LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2019 >> 718 Boxster Base, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (47 Brakes- Brake Hydraulic System, Regulator, Booster 2.5L -- 982 - BOXSTER/CAYMAN) >> WM, 471519 Removing And Installing Brake Master Cylinder >> Subsequent Work

Subsequent Work

WARNING: This page is about a different variant/trim than selected.
  1. Fill brake fluid reservoir -1-  with brake fluid.
    1. 1.1  Unscrew threaded covert on brake fluid reservoir -1-  .
    2. 1.2  Fill brake fluid into the brake fluid reservoir until the brake fluid level in the brake fluid reservoir -1-  is between MIN -arrows A-  and MAX -arrows B-  .
    3. 1.3  Tighten threaded covert on brake fluid reservoir -1-  .
    4. 1.4  Clean off any escaping brake fluid immediately using suitable cleaning aids.

      Wash affected components again with water and dry them.

      G14948286Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Filling brake fluid reservoir

  2. Bleed the brake system.

    > 470107 BLEEDING THE BRAKE SYSTEM 

  3. Only for vehicles with manual transmission:  Bleed the clutch system

    > 300107 BLEEDING THE CLUTCH SYSTEM

  4. Install alarm siren.

    > WM, 966519 REMOVING AND INSTALLING ALARM SIREN