LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2019 >> 718 Boxster Base, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (30 Clutch, Actuation 2.5L -- 982 - BOXSTER/CAYMAN) >> WM, 302019 - Removing And Installing Clutch Master Cylinder >> Preliminary Work

Preliminary Work

WARNING: This page is about a different variant/trim than selected.
WARNING: Danger of injury and damage from brake fluid!
  • Poisonous if swallowed!
  • Irritation and damage to skin
  • Avoid contact with paint surfaces
    • forward Store brake fluid in suitable, labelled containers only
    • forward Wear protective gloves and goggles
    • forward In the event of contact (eyes or skin), wash immediately with water
    • forward In the event of contact with paint surfaces, wash off immediately with water - do not wipe off
  1. Drain brake fluid reservoir until the brake fluid level is below the adapter (line to the clutch master cylinder).
    1. 1.1 Or:  Pump out some of the brake fluid at the front left brake calliper.
    2. 1.2 To do this, open a ventilation valve (use a collecting bottle) and pump the brake pedal until the fluid level in the reservoir has dropped as required. The wheel does not need to be removed for this.
  2. Remove wiper linkage.

    > WM, 921919 REMOVING AND INSTALLING WIPER LINKAGE