Installing Coolant Line
WARNING: This page is about a different variant/trim than selected.
- Installation is performed in reverse order to removal.
Replace sealing rings and grease with Kluberplus Gel (Part No. 000.043.205.93).
Fastening screw securing coolant line holder to turbocharger > Tightening torque 10 Nm (7.5 ftlb.) .
Fastening screw securing coolant line holder to distributor housing > Tightening torque 10 Nm (7.5 ftlb.) .
Fastening screw for coolant line holder, top > Tightening torque 10 Nm (7.5 ftlb.) .