LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2019 >> 718 Boxster Base, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (19 Engine - Cooling 2.5L -- 982 - BOXSTER/CAYMAN) >> WM, 195819 - Removing And Installing Coolant Regulator >> Removing Coolant Regulator

Removing Coolant Regulator

WARNING: This page is about a different variant/trim than selected.
WARNING: Caustic fluids 
  • Danger of chemical burns 
    • → Wear personal protective gear.
    • → Ensure that there is good ventilation.
    • → Avoid contact with caustic fluid.
    • → If you do come into contact, wash off immediately with plenty of warm water and contact a doctor if necessary.
  1. Unscrew fastening screws -2-  and remove heat shield -1-  .
    G14944867Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Heat protection on coolant regulator

  2. Release and disconnect electric plug connection -1-  on the coolant regulator -2-  .
  3. Have a suitable container ready for collecting coolant.
  4. Remove coolant regulator -2-  .
    1. 4.1 Unscrew and remove fastening screw -3-  .
    2. 4.2 Remove coolant regulator -2-  from the housing and collect emerging coolant.
    G14944868Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Coolant regulator