Bleeding The Cooling System
WARNING: This page is about a different variant/trim than selected.
Information
- The bleeding process for the cooling system is performed using the "Bleed cooling system" function in the PIWIS Tester.
- Always follow the instructions on the Tester.
Information
- There is no need to create a Vehicle Analysis Log (VAL).
- Connect a battery charger.
- PIWIS Tester must be connected to the fuse carrier in the passenger compartment at the left.
- Switch on ignition and Tester.
- Select the vehicle and then select DME in the control unit search.
- Switch to the Maintenance/repairs menu and select the function Bleed cooling system .
- Perform the bleeding process in accordance with the specifications and steps displayed on the Tester.