Assessment Of The Wheel Suspension Of A Vehicle Involved In An Accident
The wheel suspension may have to be replaced in the following situations:
Visible or perceptible damage to the wheel suspension (non-specific bumps or depressions, sharp fracture/crack edges).
Leaks on the bellows (e.g. from the lower trailing arm ball joint, drive shaft, etc.) as a result of the accident, which can be seen as grease or oil leaks.
Steering wheel out of line while driving straight ahead (due to the rear axle geometry).
Unknown noises or vibrations while driving.
Permanently visible deformation, damage or fractures on:
| 1 | Wheel rims/tires (including wheel bolts) |
| 2 | Wheel bearing housing (including wheel bearing and wheel hub) |
| 3 | Trailing arm, diagonal arm and tie rod |
| 4 | Rear-axle carrier side section (including anti-roll bar and connecting links) |
| 5 | Rear-axle cross member (including support plate and transverse strut) |
| 6 | Diagonal brace and V-strut |
| 7 | Drive shaft |
| 8 | Spring strut |
| 9 | Points on the body where wheel suspension parts are bolted on |
If damage is found on components listed above, they must be replaced.
The number of components to be replaced depends on the overview of parts provided above and the sequence (e.g. if component no. 4. - rear-axle carrier side section - is faulty, parts 1 to 3 must also be replaced).
If the situations listed above are not sufficient for making a decision, we recommend that you replace the components described here.