Subsequent Work
WARNING: This page is about a different variant/trim than selected.
WARNING:
Combination sensor not calibrated or calibrated incorrectly
- Unexpected vehicle handling
- Combination sensor does not work
- Malfunction in combination sensor
→ Calibrate the vehicle after installing or replacing the combination sensor using > 9818 - PIWIS Tester II
→ Only perform calibration when the vehicle is positioned horizontally and the brake is not actuated.
- Calibrate rotation-rate sensor using > 9818 - PIWIS Tester II
To do this, select:
→ Control unit overview
→ PSM
→ Maintenance/repairs
→ Select Sensor cluster calibration (combination sensor) and start calibration
Calibration is then complete.
- Only for vehicles with manual transmission (l-no. 480)
Install gearshift bracket.
- Only for vehicles with PDK (l-no. 250)
Install selector support.