Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Steering wheel to steering shaft | Internal serration screw (M18)/always use new screw following removal | Initial tightening | 30 Nm (22 ftlb.) | ||
|
Steering wheel on steering shaft |
|||||
| Steering wheel to steering shaft | Internal serration screw (M18)/always use new screw following removal | Final tightening | + 90° | ||
|
Steering wheel on steering shaft |
|||||